Validated on FPGA
High-speed links
Hercoss's own Ethernet and SerDes cores, tested on real hardware: 103 Gbit/s over four lanes and a 40G Ethernet link to a commercial network card.
- 103 Gbit/s measured
- 40GbE vs commercial NIC
- 1-hour soak, zero errors
- 25G Ethernet

What they are
Moving large amounts of data between chips means sending bits one after another over a few wires at very high speed. The blocks that do this are a SerDes (serializer/deserializer), which handles the raw bit stream, and on top of it the PCS and MAC, which turn that stream into Ethernet frames. Hercoss designs all three layers itself.
SERDES_256G
A multi-lane serial link with Hercoss’s own 64B/66B line coding. The architecture is eight lanes of 32 Gbit/s, for 256 Gbit/s in total.
On an AMD Versal FPGA it has been validated at four lanes of 25.78 Gbit/s, the highest rate that board’s transceivers accept: a 103 Gbit/s line that ran a one-hour soak test with zero errors, in near-end loopback. Still open: a test over an external cable and the full eight lanes at 32 Gbit/s on a larger board.
40G Ethernet
Two cores, PCS_40G and MAC_40G, form a complete 40GBASE-R Ethernet port.
It was tested against a commercial network card, a Mellanox ConnectX-3 Pro,
over a 3 m copper cable:
- The link comes up and all four lanes align.
- The board answers
pingfrom the PC. - PAUSE flow-control frames are obeyed.
- A one-hour soak finished with zero errors and identical frame counts on both sides.
25G Ethernet
PCS_25G and MAC_25G provide a 25G port with a 64B/66B encoder, validated
on FPGA in loopback.
What is 64B/66B coding?
A receiver can only recover the clock from a signal that changes often enough. 64B/66B adds two marker bits to every 64 bits of data and scrambles the rest, guaranteeing those changes at a cost of only about 3% extra bandwidth.
What is a soak test?
Running the link continuously for a long time while counting every error. A link that works for a few seconds can still fail once an hour; the soak test is what shows it is stable.
Why test against a commercial network card?
A core that only talks to itself can contain an error on both ends that cancels out. Interoperating with hardware from another manufacturer proves the core follows the standard.