Validated on FPGA · In development
RISC-V processor cores
Processor cores written from scratch in VHDL: a 64-bit core intended for production and an experimental 128-bit core that has already run on real hardware.
- RV64IMAC
- RV128IMAC (dual mode)
- 29/29 tests on hardware
- VHDL-2008

What they are
A processor core is the part of a chip that executes software instructions. Hercoss writes its own, following the open RISC-V standard, so they can be adapted, hardened and integrated without a licence from a processor vendor.
What does RV64IMAC mean?
It is the RISC-V way of naming what a processor can do:
- RV64: 64-bit registers and addresses.
- I: the base integer instruction set.
- M: hardware multiply and divide.
- A: atomic operations, needed for multi-core software.
- C: compressed 16-bit instructions, which make programs smaller.
That combination is enough to run Linux and real-time operating systems.
RV64IMAC
The 64-bit core, in development and intended for production. It is the base of the family: it talks directly to the rest of Hercoss’s IP cores.
RV128IMAC
An experimental core that explores the 128-bit variant of RISC-V. It is a dual-mode core: at reset it starts either as RV128 or as RV64, so operating systems that exist today run in 64-bit mode on the same hardware.
Its bare-metal version has been validated on an AMD Versal FPGA: all 29 programs of its test suite produced the same results on the hardware as on the reference instruction-set simulator.
Why 128 bits?
No application needs a 128-bit address space today. The core is a research vehicle: a way to try architectural ideas on a compact design before deciding whether they belong in a production processor.
How are the cores verified?
In two steps. First in simulation, where every program is run both on the VHDL design and on a software model of the instruction set, and the results are compared. Then on real hardware, running the same programs on an FPGA. A core counts as validated only after the second step.